Component Description

Typicaly the Qucs schematic is saved as a .sch file to store the components, wires, painigs and settings defined by the user. Prior to simulation with Qucsator the schematic is translated into a .txt netlist file which is presente to the simulator. The general format of schematic and netlist entries are listed below.

Schematic Component

Schematic entry general form:

<[model] [name][number] active x y xtext ytext mirrorX rotate ["value" visible]* >

Examples:

<R R1 1 170 90 -26 15 0 0 "50 Ohm" 1 "26.85" 0 "0.0" 0 "0.0" 0 "26.85" 0 "european" 0>

<Vdc V1 1 160 380 18 -26 0 1 "1 V" 1>

<GND * 1 160 470 0 0 0 0>

<Circulator X1 1 410 400 -26 -33 0 0 "50 Ohm" 0 "50 Ohm" 0 "50 Ohm" 0>

Note that the GND ground componet will not be present on the netlist. The ground node is unique and implicitly devined by the simulator.

Netlist Component

Netlist entry general form:

[model]:[name][number] _net[number]+ [propery="value"]*

Examples:

R:R1 _net0 _net1 R="50 Ohm" Temp="26.85" Tc1="0.0" Tc2="0.0" Tnom="26.85"

Vdc:V1 _net6 _net7 U="1 V"

Circulator:X1 _net16 _net17 _net18 Z1="50 Ohm" Z2="50 Ohm" Z3="50 Ohm"